Aeronaut Automation

Automated Cutting Systems & Software

Shade Sails

Designing patterns for shade cloth structures and shade sails is an easy task with Aeronauts Vectorworks multi-sided shades plug-in. Using measurements taken on site, you can design structures with 3-6 sides, generate the panels, and have them ready to cut in minutes.

Structures with many more than 6 sides can be designed by breaking up the shape into simpler areas. These techniques cover the vast majority of simple surfaces made from fabric such as shade cloth, where a full 3D surface model is not necessary.

To begin with, you need to know the length of each side, and check diagonals. If all these cant be measured on site, you can draw a quick ground plan in Vectorworks and calculate what you cant measure. Lines can be easily dimensioned in Vectorworks, the area and perimeter calculated to the millimetre.

Shade Sail Plug-in Tool

If the pattern shape is not flat, the multi-sided shades plug-in will calculate the foods high in cholesterol lengths of edges in a 3D plane so the final fabricated shape accurately fits the structural components and the ground plan.

Working in a clockwise direction, you enter the dimensions into the Generate Shades macro first side length, second side and propranolol social anxiety check diagonal, and so on, finally entering the last edge.

The shape will be generated as one single polygon or a series of triangular polygons for easier or more attractive panel layouts. You can choose to put hollow into any unsupported edges. The amount of hollow in the unsupported in Vectorworks, and the centre position of the triangular panels can be moved.

The generated shape has check dimensions so you can compare it with the original ground plan.

When the shape has been generated in Vectorworks you add any seam or welding allowances, rope edges, and deductions for corner fittings and reinforcements.

Shade Sail - Add Seams

If you know the stretch factors of your fabric, its a simple matter to proportionally scale panels to adjust for fabric stretch.

The resulting panels are then imported into Tangent for nesting, plotting and cutting. You can get accurate figures of edge lengths in Vectorworks for calculating wire quantities.

Tangent will give you a figure for fabric length and waste.

Shade Cloth Hypars can also be made using the Generate Shades macro. This duplicates the methods used on the floor to make hypars from shade cloth and other fairly stretchy fabrics, where the tension on the fabric and its stretch factor are used to get a fair 3D shape.

The macro generates four sided shapes, and these sides can be of any length. Five or more sided Hypars can be made by clipping any corner in Vectorworks to get the final shape. The shape can be slightly rescaled in Vectorworks to correct for fabric stretch, rope edges added, and the shape exported into Tangent.

Splitting Panels in Tangent

In Tangent, you can split panels and add seam allowances just by reducing the width of the fabric. When a panel is imported into Tangent which is wider than the set fabric width, Tangent will ask if you want to split the panel and Сapoten 25mg add a seam allowance, or to adjust the fabric to suit the panel.

Setting the fabric width to less than the panel width at any time will bring up this dialog, allowing an easy way of splitting panels.

Aeronaut's set of shade sail plug-in tools is an economical and effective way of rapidly developing shade sail patterns, ready for cutting. This may be all you need. However, if you are fabricating tension structures or other lightweight fabric structures, you will probably need more extensive software. Have a look under the tension structures category for information on this.